Description
Blackfriar Brick & Tile Paint provides a tough, self-cleaning, weather-resistant finish. In attractive matt tile red, it is absolutely ideal for doorsteps, roof tiles, bricks and masonry, both inside and outside. Revive your faded bricks and tiles with Blackfriar Brick & Tile Paint.
Preparation
Make sure the surface to be painted is clean, dry and free from any contaminants. Remove any mould – if using an anti-mould solution then allow to dry completely.
Application
Stir well with a broad stirrer. The manufacturer recommends two coats for the best protection. The product can be applied with brush, roller or spray, but applying with a brush is recommended. Only thin to a maximum of 5% white spirit. Do not paint in cold (under 5°C), damp or humid conditions. Not suitable for floors/foot traffic areas or for quarry tiles.
- Coverage of up to 14m² per litre per coat
- Touch dry in 2-4 hours
- Recoat after 16 hours and within 3 days
Drying times are based on an ambient temperature of 20°C and 50% relative humidity. Lower temperatures or higher humidity will prolong the drying and overcoating times.
Caution
- Not suitable for use on quarry tiles. Blackfriar have specific products for floors and steps.
- Do not use under cold (less than 5°C), damp or humid conditions.
- Spreading rate of the first coat may be reduced on porous surfaces.
- Store in a dry, safe place. Do not store in environments where extreme temperatures may occur. Keep within 5-30°C. Do not store in direct sunlight.
Safety
- Keep out of reach of children.
- Read label before use.
- Flammable liquid and vapour. Keep away from heat, sparks, open flames, hot surfaces.
- Use only in well-ventilated areas. May cause drowsiness or dizziness.
- If on skin, rinse skin with water or shower.
- If medical advice is needed, have product container or label at hand.
Living-room 
Bedroom