Sadolin Yacht Varnish

Description

Sadolin Yacht Varnish is a traditional clear varnish used to build a durable, high gloss finish. With a High Gloss finish, Sadolin Yacht Varnish has been formulated with a completely clear formulation – ideal to enhance the natural beauty and colour of wood. Developed by our wood care experts with protective UV additives, our premium formulation protects against damaging UV light, providing long lasting protection that resists peeling and flaking with its high-build protective barrier.

Preparation – General Timber Advice

• Timber surfaces must be suitably prepared.
• The moisture content should not exceed 18% prior to coating.
• Resinous deposits should be removed.
• Degrease any exposed bare timber by wiping with a clean, lint free cloth dampened with methylated spirits, frequently changing the face of the cloth.
• Allow the solvent to fully evaporate.
• Abrade sound timber surfaces in the direction of the grain using medium/medium fine grade (P180/P240) pads/abrasive paper (nothing metallic), taking care not to damage or scratch across surfaces.
• Remove dust.
• “Knotting agents” should not be used with Sadolin systems.
• Use Sadolin Woodfillers to make good any minor surface defects.
• General or all purpose fillers are not suitable.
• We recommend the use of non-ferrous screws, nails and fixings.
• Exposed ferrous items may corrode and break the coating film over time if not suitably primed/treated prior to decorating.

Preparation – New Timber

• All surfaces must be sound, suitably dry and free from anything that will interfere with the adhesion of the materials to be applied.
• Coat any non treated wood with two liberal coats of Sadolin Wood Preserver paying particular attention to end grains.
• Allow 24 hours before overcoating.
• Where possible, the basecoat, Sadolin Yacht Varnish, should be applied, all round, prior to fixing.

Preparation – Previously Coated Timber

• All surfaces must be sound, suitably dry and free from anything that will interfere with the adhesion of the materials to be applied.
• Remove all defective coatings.
• Grey denatured timber should be thoroughly sanded back to clean, bright timber and treat as new.
• Organic growths should be treated with a suitable fungicidal solution and removed.
• Remaining sound surfaces should be cleaned with warm water and mild detergent, rinse thoroughly with clean water and allow to dry.
• Lightly abrade in the direction of the grain, taking care not to break the surface coating.
• Remove dust.
• Localised damage, or severe deterioration of coating requires thorough sanding back to sound substrate and recoated.
• If a coloured base stain is required in order to match the existing or factory applied coating, use Sadolin Classic in the most appropriate colour.

Application

• The final colour and sheen of translucent coatings are dependent on timber species, colour, cut and presence of existing coating amongst other factors.
• We recommend a trial application in an inconspicuous area prior to commencement of work to check for colour accuracy.
• Always intermix (box) packs for colour consistency.
• On new wood: For a clear finish apply 3 coats of Sadolin Yacht Varnish. For a coloured base apply 1 coat of Sadolin Classic followed by 3 coats of Sadolin Yacht Varnish.
• On previously coated timber apply 2 coats of Sadolin Yacht Varnish
• With certain substrates profiles and colours, it may be necessary to apply additional coats to achieve required colour.
• Stir well before and during use.
• Use a good quality synthetic bristle brush.
• Apply in a full flowing coat maintaining a wet edge.
• Ensure all surfaces, tops and bottoms of doors, end grains and undersides of cills are coated.
• Avoid overspreading.