Description
Teknos Nordica Classic Semi-matt ( around 40% Sheen ) acrylate-based, water-borne paint designed for exterior wooden surfaces but can be used equally indoors as well. Environmentally friendly façade paint the Nordica range offers great durability: leaving a hard surface that is dirt-repellent and which retains its appearance and colour for long period of time.
New and previously with acrylate painted wooden surfaces, e.g. exterior walls, facial boards and weather boards. Teknos Nordica Classic may also be used for maintenance painting on most old oil and alkyd paints, if the surfaces are in good condition. The system is used extensively in Nordic countries to paint their timber clad houses, barns and places of work.
NEW SURFACES:
- It is recommended to paint new surfaces as soon as possible. At least the impregnation and priming would be best done in the summer of construction.
- Remove from the surface all loose matter, dirt, dust and mildew. If needed, use RENSA FACADE facade cleaner. Apply a coat of clear wood preservative from the WOODEX series. Allow to dry for one day.
- Prime wooden surfaces with NORDICA PRIMER and allow the surfaces to dry for 1 – 3 days depending on the weather.
- Wash the metal parts with TEKNOSOLV 1621 (solvent naphtha) and prime with FERREX AQUA.
PREVIOUSLY PAINTED OR OLD SURFACES:
- Replace deteriorated wooden parts with new ones. Remove loose matter, dirt and dust. Remove the deteriorated paint coats entirely. Note, that the adhesion of an old thick paint layer to the substrate may have been weakened, therefore the paint should be removed although the paint film looks intact.
- The old paint layer is removed primarily by scraping or wire brushing and possibly by heating the surface with infra-red heater designed for that purpose. Secondarily paint remover or blasting can be used.
- The surface of old oil paint coats may be in poor condition: heavily chalked, dusty and brittle. These types of surfaces must be carefully cleaned so, that the new paint adheres properly to the substrate.
- Some traditional paint types, such as red ochre paint and paraffin oil paint, produce such a brittle and dusty surface, that they can’t be maintenance painted with NORDICA CLASSIC. If there is doubt about the adhesion, it must be ensured by test painting.
- Wash surfaces with RENSA FACADE façade cleaner and rinse thoroughly.
- Old, untreated wooden surfaces can before the priming be treated with clear wood preservative from the WOODEX series, see ‘NEW WOODEN SURFACE’.
- Prime bare wooden surfaces with NORDICA PRIMER. Allow to dry for 1 to 3 days depending on the weather. Wire-brush the rusty metal parts. Wash all metal parts with TEKNOSOLV 1621 (solvent naphtha) and prime with FERREX AQUA.
APPLICATION
Brush, Roller or you can airless spray nozzle is 0.015 – 0.019″.
APPLICATION CONDITIONS
Must be dry. Moisture content of timber should be below 20%. Ambient temperature should be above +5°C and the relative air humidity below 80%. Avoid application in direct sunlight.
STORAGE
Must not freeze.
Please Note :
- Mixed paints are Non Returnable and Non Refundable. They are made to order, all colours are made using approved manufacturers materials and equipment.
- Due to varying screen resolutions, colour swatches shades can vary when mixed in to paint. We would recommend the purchase of a Tester Pot if you are unsure, this would give a more accurate reference of the colour, also looking at the shade in the home environment would give additional assurance as colours are influenced by there surroundings ( Metamorism ).
- It is the customers responsibility to ensure you order the correct colour.
Living-room 
Bedroom