Zinsser Peel Stop Primer Paint – Clear

Description

Zinsser Peel Stop is a clear, flexible bridging sealer for surfaces with various issues such as peeling, flaking, chalking, blistering or dusting. It can be used in both interior and exterior settings to form a breathable membrane over questionable or faulty substrates.

Zinsser Peel Stop tightly bonds to old paint and problem areas forming a sound surface for new paint, forming a tough acrylic film that stays flexible and helps to prevent peeling by letting moisture escape.

Peel Stop tackles a range of problems, including; peeling, blistering, checking, cracking and flaking. Suitable for a variety of substrates, including but not limited to; wood siding and trim, yellow pine, rough sawn cedar, textured plywood, chalking or powdering, concrete and concrete block, stucco and galvanized gutters.

Preparation

• Thorough surface preparation is very important. Surfaces should be sound, clean, dry, and free from dust, dirt, grime, grease, oil, wax, mould, wallpaper adhesive, or any contamination that may interfere with adhesion.
• If unsure, always wash surface with an appropriate cleaning solution or solvent.
• Thoroughly scrape and sand surfaces to remove all poorly adhered paint.
• Lightly sand exposed wood to remove loose fragments.
• Dull glossy painted areas with sandpaper.

Application

• Apply when air and surface temperatures are between 10? and 32?C and humidity is less than 80%. Lower temperatures and higher humidity can prolong drying time. If conditions do not permit prompt drying, allow Peel Stop to dry overnight before priming or painting.
• Do not apply Peel Stop if rain is expected and primer or topcoat cannot be applied before rain occurs.
• Shake or stir well before using.
• Do not thin.
• Apply with brush and/or roller or airless sprayer.
• Back brush or roll to work Peel Stop into cracks and edges of old paint.
• Proper application of Peel Stop will dry to a slight sheen. Apply a second coat if dull spots appear.
• For best brushing performance use quality synthetic bristle brushes. Zinsser do not recommend natural bristle brushes for use with the product.

For further information consult the Technical Data Sheet and Safety Data Sheet attached.