Treatex Hardwax Oil Hardener 1140

Description

Treatex Hardwax Oil Hardener 1140 is an additive for the Hard Wax Oil range which increases the mechanical resistance of the finished surface. The new formula has a mixing ratio of 20:1 (50ml : 1lt) and can be added to both coats, to single coats, or just to the final application. This product is often used to increase durability of the coating in high traffic areas and reduces the time it requires to dry.

Once mixed Treatex Hardwax Oil Hardener starts a reaction which cannot be stopped and you will have a 3 hour window of application before the mix will go off and it will not be usable. Therefore, we strongly advise that you fully prepare to apply the mix prior to adding the hardener.

• For a 1lt tin of Hardwax Oil, add 0.05lt of the Hardener.
• For a 2.5lt tin of Hardwax Oil, add 0.125lt of the Hardener.

Safety

In all cases of doubt, or when symptoms persist, seek medical attention. If unconscious place in recovery position and seek medical advice. First aider: Pay attention to self-protection! Remove affected person from danger area, lay him down.

• After inhalation – In case of accident by inhalation: remove casualty to fresh air and keep at rest. Keep warm, calm and covered up. In all cases of doubt, or when symptoms persist, seek medical attention.
• After skin contact – Wash off immediately with soap and water. Do NOT use solvents or thinners. Consult a doctor if skin irritation persists.
• After eye contact – Remove any contact lenses, irrigate copiously with clean, fresh water, holding the eyelids apart for at least 10 minutes and seek immediate medical advice. Take medical treatment.
• After ingestion do not induce vomiting. Take medical treatment.

Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limits. Keep container tightly closed and dry in a cool, well-ventilated place. Use only with adequate ventilation/personal protection. Wear a suitable respirator if the ventilation is not sufficient to keep the solvent vapour concentration below the occupational limit values. Persons with a history of asthma, allergies, chronic or recurrent respiratory disease should not be exposed to any process in which this mixture is used. Avoid contact with skin and eyes. Avoid inhalation of vapour and spray mist. Do no eat, drink or smoke when using this product. Use personal protective clothing.