Wallrock Thermal Liner Adhesive

Description

Wallrock thermal Liner adhesive is a strong water based paste the wall adhesive. The paste the wall formula will also assist in filling small cracks making the filling and preparation time quicker and easier. Thermal liner adhesive is specially formulated to apply Wallrock thermally efficient wallpapers, suitable also for polystyrene insulation products, PUR sound insulation. Easy roll paste the wall formulation for quick easy application directly to the wall using a roller or a brush. Typical consumption of 2m² to 1.5m² per kg

Before use:

This product is ready-mixed and ready to use, however some storage conditions may contribute to separation of water, visible on top of the product. This can be easily stirred into the bulk of the product without effecting the performance properties of the product. Despite stringent quality assurance procedures, defects may occur in exceptional cases from time to time. If a fault is found, please return any defective material to the place of purchase. Please see wallpaper roll labels for hanging instructions for each individual lining system.

Surface Prep:

Wallrock Thermal Liner Adhesive can be used on most internal wall surfaces. The adhesive contains filler and can be used in conjunction with our wallcovering products to cover surface imperfections and textures. All surfaces should be firm, dry and clean, all loose material should be removed before the adhesive is applied. Major surface imperfections should also be filled and levelled in preparation. Drywall and other absorbent surfaces should be sized and completely left to dry for at least 4 hours before application of the adhesive.

How Much Will You Need:

Each adhesive container holds 10kg (22lb), sufficient for 1 roll of Wallrock Thermal Liner KV600, 2 rolls of Wallrock Thermal Liner or 3 rolls of wallrock R300 Cosy Liner. Where the surface being covered is flat and in relatively good condition coverage will improve significantly by up to 25%. See guidance chart for other products.

Application:

The room temperature and that of the adhesive should not be less than 10°C/50°F. Please keep the adhesive sealed when not in use.

1. Generously apply the adhesive directly to the wall using a deep pile roller, use more paste if the wall is textured or damaged.
2. Apply adhesive to an area a little wider than for one length, this will ensure an adequate area is covered and make the next length easier to apply.
3. In the areas which the roller cannot reach, such as corners, the paste should be applied with a spatula or brush.
4. Each length of wallcovering should be butt jointed. Remove excess glue immediately with a damp cloth or sponge.

Drying:

Drying time depends upon room temperature, humidity, thickness of the paste layer and surface absorbency but is normally complete after 24 hours. In some circumstances you may have to wait longer before any other wallcoverings are applied to the Thermal Liner. Check for adhesion before commencing any subsequent redecoration. The adhesive may be used to fill any small gaps at the seams, smooth down using sandpaper before decoration.

Important Note:

1. Do not thin or add water to the adhesive.
2. Contains fungicide and biocide to inhibit mould, yeast and bacteria. Keep away from children and animals. Wash hands thoroughly after use.
3. Do not empty into drains or watercourses. Waste should be disposed of using authorised disposal routes and sites.