Description
Zinsser AllCoat Exterior is a high quality, mould resistant paint that provides superb protection to all exterior surfaces, including wood, metal, masonry, concrete, cladding, plastic and more. It forms a vapour-permeable, low maintenance, water-shedding coating that is recoatable in just 1 hour.
Zinsser AllCoat Exterior is self priming and can be applied to previously painted surfaces without sanding. You do not even need to sand glossy paints or those coated with bitumen, tar varnish or creosote. With exceptional resistance against cracking, blistering and flaking, the resultant tough finish is resistant to rain and severe weather and offers excellent colour retention. This paint also contains a biocide that protects the dried coating against fungal degradation. After sufficient preparation and tackling mould and mildew, two coats of AllCoat will ensure that any exterior surface looks bright and beautiful for years to come.
The first coat primes and seals the surface, providing a base for the topcoat. The topcoat then completes the sealing process while providing additional moisture resistance and protection. This paint is ideally suited to exterior buildings with timber and metal cladding.
Preparation
- Surfaces should be sound, clean, dry, and free of any contamination that may interfere with adhesion. Remove all loose or peeling paint and chalky paint residue. Sand edges of any remaining paint film until smooth.?
- Ensure that new concrete, masonry and other related surfaces has been cured at least 30 days before priming.
- Remove all existing mould and mildew before painting. To effectively remove mould and mildew, dirt and chalky paint residue, use Zinsser Mould Killer & Remover or an exterior house cleaner following the manufacturer?s instructions.
- Treat any timber at risk from decay or insect attack with an appropriate preservative.
- Ensure the surface is completely dry before painting. For porous surfaces such as timber or masonry, we recommend moisture content of the substrate should not exceed 12%.
Application
- Shake or stir well before using.
- Apply with synthetic bristle brush, roller or sprayer. For airless spraying, use a .017? tip and high-medium (2000-2500 PSI) pressure.
- Ensure air and surface temperature are between 10? & 32?C and humidity is less than 85% during application and cure of the product.
- Avoid painting in direct sunlight and maintain a ?wet edge? to avoid lapping.
- Ensure conditions during application and cure are favourable, do not apply if there is a likelihood of rain, frost, fog or condensation affecting the freshly applied paint before it has fully cured.
For further information consult the Technical Data Sheet and Safety Data Sheet attached.
Living-room 
Bedroom